No.
|
Manf #
|
H2O #
|
Description
|
1 |
Generic |
9433143 |
Drain Plug
w/o O-ring |
2 |
Generic |
9094189 |
O-Ring for drain plug - Generic |
3 |
Discontinued |
-------- |
Volute, 2" Discharge -
Discontinued |
4
|
Generic
|
9433640 |
O-Ring, Buna-N, 6" ID, 3/32" Cross Section -
Generic |
5
|
1212227
|
9433196 |
Impeller, 1.5 hp,
Green / Blue / Red / Blue
- Note 1 |
5
|
1212230
|
9433198 |
Impeller, 2.0 hp,
Green / Brown / Red
- Note 1 |
5
|
1212235
|
9433200 |
Impeller, 3.0 hp,
Green / Red
- Note 1 |
5
|
1212008
|
9433202 |
Impeller, 4.0 hp,
Green / Orange / Red / Brown
- Note 1 |
6
|
PS-201
|
9091320 |
Shaft Seal, PS-201, ( manf = U.S.Seal ) |
7 |
Discontinued |
-------- |
Volute back, Ultimax -
Discontinued |
8 |
6010001 |
-------- |
Nut, 1/4-20,
5 required |
9 |
6011003 |
9433059 |
Bolt, 1/4-20 x 2-3/4" ,
1 required |
10 |
6011012 |
9433047 |
Bolt, 1/4-20 x 1-1/2",
4 required |
11 |
2614029 |
-------- |
Pump Union, 2"bt x 2"s |
12 |
1217179 |
-------- |
Bracket Adapter -
Note 2 |
13 |
6012011 |
-------- |
Screw for bracket, 8-32 x 5/8",
4 required |
Note 1 - In some cases, when replacing the impeller, the shaft of
the impeller may need to be shortened. This might be the case if the
motor does not require the use of the 'Bracket Adapter' to bolt up to
the Ultimax wet end.
Note 2 - This 'Bracket Adapter' may or may
not be in use, depending on the configuration of the motor.
This bracket was used on 56 Frame GE Motors.
|
last updated - November, 2013 |
|