Directions:
   1. Adjust pH and total alkalinity of freshly filled spa to proper levels.
       ( pH level: 7.2 - 7.8 ppm total alkalinity level: 80-120 ppm )
   2. Add entire bottle to filled spa while the filter is running.
   3. pH will instantly increase or decrease to a reading between the ideal range of 7.2 to 7.8.
Tip: Add to freshly filled water.  pH Balance should not be used in hard water areas where the calcium reading is above 150 ppm. In these conditions, this formula will soften hard water and release calcium into spa water possibly causing cloudy water, scaling and clogging of spa filter. If you are not in a hard water area, but experience clouding of spa water after applying pH Balance, Leisure Time recommends using Bright
& Clear to return clarity to water.
 

Directions:
   1. Add 1-1/2 lbs. (half the jar) of pH Balance Plus for up to 250 gallons of spa water or the entire 3 lbs.
for up  to 500 gallons of spa water. Pour directly into spa.
   2. Turn on jets and allow water to circulate for 15 minutes. Temporary cloudiness may occur, but the water will clear quickly once the product is fully dissolved.
   3. Repeat the application each time you refill your spa with fresh water.

Tip: If local water conditions are extreme or spa usage is very heavy, first use Spa Up or Spa Down to bring the pH into the general range of 7.0-8.0, then follow the directions on the bottle. Once added, pH Balance Plus will lock in pH levels.