Spas:
Use Jet Clean every 3 months or when spa is drained and refilled.:

1. Remove filter and clean separately using Filter Clean.
2. Before spa is drained, add 1 bottle of Jet Clean to warm spa water.
3. Turn pump ON and run the jets for 15 minutes (ensure that filter is not in spa).
4. Turn pump and jets OFF and let sit for 1 hour.
5. Turn pump ON and run jets and blower for 15 minutes.
6. Drain the spa, hosing off the inside spa walls while draining.
7. Refill the spa according to the Simple Spa Care Program.

For Jetted Bath Tubs:
1. Pour 8 oz. (1/2 bottle) in tub with warm water before draining.
2. Turn jets ON for 15 minutes. 3. Drain and rinse tub with clean water.

Tip:
Jet Clean should be applied each time a spa is drained and refilled so jets continue performing like new.
 

Directions:

1. Remove cartridge filter elements.*
2. With spa water temperature at 95'F or higher, add entire contents of 1L Spa Purge bottle to spa water.
3. Run jets a minimum of 5 minutes. (If excessive foaming occurs turn jets off.)
4. Maintain water temperature and allow spa to circulate overnight with jets off.)
5. Drain, rinse and then refill spa and reinstall filter elements. Proceed with normal spa maintenance.

*For complete spa cleaning, soak cartridge filter elements overnight in the only all natural filter cleaner - Filter Perfect
 

 
Bottle contains a red measuring cap that fits over the child proof cap.

FLUSH CLEANING JETTED BATHS:
  Place plug in bath and start filling with cold water.
  When bath has filled to 2 inches above jet line add SPA.GIENE as directed. (normally 50 ml, 1 red caps full )
  Turn on pump and air.
  Turn on exhaust fan. Foaming will occur. You will see areas of brown and yellow foam ( body fats ).
  After 10 to 15 minutes turn off pump. Pull plug, and with diluted product in spray bottle, wipe any excess scum marks/water lines off surface and surrounding area of spa bath.
  As the foam and traces of body fat dissipate and go down the drain, wipe bath with cloth and running water.
  Once spa is emptied, wipe down dry with a second clean cloth.

Spa Maintenance:
  SPA or HOT TUB to be filled to normal level of use - Hot or Cold ( use existing water )
  Remove filter cartridge and clean separately.
  Turn on Filter Pump and add SPA.GIENE™ at a rate of 100 ml ( 2 red caps full ) for every 300-600 gallons of water or 200 ml ( 4 red caps full ) for every 600- 1000 gallons of water.
  Run for 30 minutes, foaming will occur. You will see areas of brown and yellow foam ( body fats ).
  We recommend draining the spa at this point and refilling with fresh water, hosing off the inside spa walls while draining. Before filling, wipe sides of spa clean.
  If you plan on not draining the spa and using the existing water after flushing, then follow further instructions on the back of the bottle.
  Replace with a cleaned cartridge filter upon start-up.